Installing the power-adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power-adapter port and provides a visual representation of the installation procedure.
Steps
- Lift the system board Mylar next to the left fan to access the power-adapter port slot.
- Place the power-adapter port into the slot on the system board.
- Connect the power-adapter port cable to the system board.
- Adhere the power-adapter port cable on the system board.
- Align the screw holes on the power-adapter port bracket to the screw holes on the system board.
- Replace the two screws (M2x4) that secure the power-adapter port bracket to the system board.
- Replace the system board Mylar back to the edge of the left fan.
- Route the display cable through the opening between the power-adapter port and the heat-sink assembly.
- Connect the display cable on the system board and close the latch to secure the cable.
- Connect the Alienhead LED cable to the system board.
- Adhere the display cable to the system board.
Data is not available for the Topic