Installing the base cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the base cover and provide a visual representation of the installation procedure.
Steps
- Connect the battery cable to the system board.
- Slide the notches on the top of the base cover under the rear I/O-cover, and snap the base cover into place on the palm-rest and keyboard assembly.
- Replace the two screws (M2.5x5) that secure the base cover to the palm-rest and keyboard assembly.
- Tighten the two captive screws (M2.5x8.5+3.5) that secure the base cover to the palm-rest and keyboard assembly.
- Tighten the four captive screws (M2.5x1.7+3.3) that secure the base cover to the palm-rest and keyboard assembly.
Data is not available for the Topic