Removing the display assembly
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Steps
- Open the latch and disconnect the display cable from the system board.
- Disconnect the Alienhead LED cable from the system board.
- Disconnect the RGB-IR camera cable from the USB board.
NOTE This step applies to devices that are shipped with a hybrid RGB-IR camera module.
- Lift the system board Mylar and peel the tapes that secure the RGB-IR camera cable to the system board.
NOTE This step applies to devices that are shipped with a hybrid RGB-IR camera module.
- Lift the RGB-IR camera cable off the system board.
NOTE This step applies to devices that are shipped with a hybrid RGB-IR camera module.
- Turn the computer over and place the computer on a clean and flat surface.
- Remove the display cable from the routing guides on the palm-rest and keyboard assembly.
- Remove the RGB-IR camera cable from the routing guides on the palm-rest and keyboard assembly.
NOTE This step applies to devices that are shipped with a hybrid RGB-IR camera module.
- Remove the six screws (M2.5x5) that secure the display hinges to the palm-rest and keyboard assembly.
- Lift the display assembly off the palm-rest and keyboard assembly.
- After performing all the above steps, you are left with the display assembly.
Data is not available for the Topic