- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Alienware m15 Ryzen Edition R5
- Base cover
- Battery
- Battery cable
- Solid-state drive
- Removing the 2230 solid-state drive in SSD slot one
- Installing the 2230 solid-state drive in SSD slot one
- Removing the 2280 solid-state drive in SSD slot one
- Installing the 2280 solid-state drive in SSD slot one
- Removing the 2230 solid-state drive in SSD slot two
- Installing the 2230 solid-state drive in SSD slot two
- Removing the 2280 solid-state drive in SSD slot two
- Installing the 2280 solid-state drive in SSD slot two
- Procedure to move the screw mount in SSD slot one
- Procedure to move the screw mount in SSD slot two
- Speakers
- Audio and ethernet daughterboard
- Memory module
- Wireless card
- Rear-I/O cover
- Touchpad
- Power-adapter port
- Display assembly
- Keyboard-controller board
- System board
- Heat-sink assembly
- USB board
- Power button
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Alienware
Alienware m15 Ryzen Edition R5 Service Manual
Installing the 2280 solid-state drive in SSD slot one
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE This procedure applies only to computers shipped with a 2280 solid-state drive installed in SSD slot one.
NOTE Depending on the configuration ordered, your computer may support either 2230 solid-state drive or 2280 solid-state drive in SSD slot one.
If you want to replace your 2230 solid-state drive with a 2280 solid-state drive, see procedure to move the screw mount.
The following image indicates the location of the 2280 solid-state drive that is installed in SSD slot one and provides a visual representation of the installation procedure.
Steps
- Align the notch on the solid-state drive with the tab on the solid-state drive slot.
- Slide the solid-state drive into the solid-state drive slot.
- Place the thermal shield on the solid-state drive.
- Align the screw holes on the thermal shield with the screw holes on the solid-state drive and system board.
- Replace the two screws (M2x4) that secure the thermal shield to the solid-state drive and the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\