Installing the solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
CAUTION: : Solid-state
drives are fragile. Exercise care when handling the solid-state drive.
About this task
The following images indicate the location of the solid-state drive and provides a visual representation of the installation procedure.
![Image: Installing the solid-state drive](https://dl.dell.com/topics//alienware-aurora-r9-service-manual/images/GUID-32445B2C-40C6-4262-9609-0C713A3D5013-low.jpg)
Steps
- Align the notch on the solid-state drive with
the tab on the solid-state drive slot.
- Insert the solid-state drive at a 45-degree
angle into the system board.
- Press the other end of the solid-state drive
down and replace the screw (M2x2.5) that secure the solid-state drive to the
system board.
Data is not available for the Topic