- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Inside view of your computer
- System-board components
- Recommended tools
- Screw list
- Left-side cover
- Top cover
- Right-side cover
- 2.5-inch hard drive
- 3.5-inch hard drive
- 2.5-inch hard-drive cage
- 3.5-inch hard-drive cage
- 460 W power-supply unit
- 850 W Power-supply unit
- Right tron-light board
- Processor liquid-cooling assembly
- Coin-cell battery
- Memory modules
- Solid-state drive
- Single-graphics card
- Dual-graphics card
- Front bezel
- Top bezel
- Bottom cover
- Processor fan and heat-sink assembly
- Processor
- Wireless card
- Antennas
- Front I/O-panel
- Front-chassis fan
- Top-chassis fan
- Power-button board
- System board
- Device drivers
- System setup
- Troubleshooting
Alienware Aurora R9 Service Manual
Removing the top bezel
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the left-side cover.
- Remove the top cover.
- Remove the right-side cover.
- Remove the wireless card.
- Remove the front bezel.
About this task
The following images indicate the location of the top bezel and provides a visual representation of the removal procedure.
Steps
- Remove the four screws (#6-32) that secure the top bezel to the right and left of the chassis.
- Lift the top cover off the chassis.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\