Removing the 850 W power-supply unit
Prerequisites
NOTE: : Note the routing of all cables as you remove them so that you can
route them correctly after you replace the power-supply
unit.
About this task
The following images indicate the location of the power-supply unit and provides a visual representation of the removal procedure.
![Image: Removing the 850 W power-supply unit](https://dl.dell.com/topics//alienware-aurora-r9-service-manual/images/GUID-E4E1449B-11C9-4D03-8764-D60CE3CE923D-low.jpg)
Steps
- Remove the two screws (#6-32) that secure the power-supply unit bracket to the power-supply unit cage.
- Lift the power-supply unit bracket off the power-supply unit cage.
- Press the releasing clip on the power-cable connectors and disconnect all the power cables from the power-supply unit.
- Remove the four screws (#6-32) that secure the power-supply unit to the chassis.
- Slide and lift the power-supply unit, along with the cables, off the chassis.
Data is not available for the Topic