Installing the right tron-light board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the right tron-light board and provides a visual representation of the installation procedure.
![Image: Installing the right-light board](https://dl.dell.com/topics//alienware-aurora-r9-service-manual/images/GUID-927E2D41-A1A9-4FB2-AABD-171D9A9FDECB-low.jpg)
Steps
- Align the screw holes on the right tron-light board with the screw holes on the chassis.
- Replace the four screws (#6-32) that secure the right tron-light board to the chassis.
- Connect the tron-light cable.
Data is not available for the Topic