Installing the 2.5-inch hard-drive cage
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the 2.5-inch hard-drive cage and provides a visual representation of the installation procedure.
Steps
- Insert the 2.5-inch hard-drive cage into its slot on the chassis.
- Align the tabs on the cage with the tabs on the chassis.
- Replace the two screws (#6-32) that secure the 2.5-inch hard-drive cage to the
chassis.
NOTE: : Repeat the procedure from step 1 to step 3 to install the other 2.5-inch hard-drive cage.
Data is not available for the Topic