- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Inside view of your computer
- System-board components
- Recommended tools
- Screw list
- Left-side cover
- Top cover
- Right-side cover
- 2.5-inch hard drive
- 3.5-inch hard drive
- 2.5-inch hard-drive cage
- 3.5-inch hard-drive cage
- 460 W power-supply unit
- 850 W Power-supply unit
- Right tron-light board
- Processor liquid-cooling assembly
- Coin-cell battery
- Memory modules
- Solid-state drive
- Single-graphics card
- Dual-graphics card
- Front bezel
- Top bezel
- Bottom cover
- Processor fan and heat-sink assembly
- Processor
- Wireless card
- Antennas
- Front I/O-panel
- Front-chassis fan
- Top-chassis fan
- Power-button board
- System board
- Device drivers
- System setup
- Troubleshooting
Alienware Aurora R9 Service Manual
Installing the top cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the top cover and provides a visual representation of the installation procedure.
Steps
Align the tabs on the top cover with the slots on the chassis and snap the top cover into place.
Next steps
- Install the left-side cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\