Installing the single-graphics card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the graphics card and provides a visual representation of the installation procedure.
![Image: Installing the graphics card](https://dl.dell.com/topics//alienware-aurora-r9-service-manual/images/GUID-86162645-F55D-4110-93CF-D2C01AE58746-low.jpg)
![Image: Rotating the power-supply unit cage](https://dl.dell.com/topics//alienware-aurora-r9-service-manual/images/GUID-6A16F236-0B46-4BDD-8162-E05FF1321D1B-low.jpg)
Steps
- Place the card into the X16 slot and press down firmly until the graphics card snaps into place.
- Connect the power cables to the graphics card.
- Slide the tab on the graphics-card bracket into the slot on the chassis and rotate it into place.
- Rotate the power-supply unit cage towards the chassis.
- Slide the power-supply unit cage release latches towards the locked position.
Data is not available for the Topic