The drive carrier module consists of a disk drive that is installed in a carrier module.
Drive slots:
Each 2U12 drive slot holds a single low profile 1.0 in. high, 3.5 in. disk drive in its carrier. The disk drives are installed horizontally. A 2.5" to 3.5" carrier adapter is available to accommodate 2.5" disk drives.
Each 2U24 drive slot holds a single low profile 5/8 inch high, 2.5 in. disk drive in its carrier. The disk drives are installed vertically.
Mounting locations: Direct doc SAS drives.
Drive carrier:
A sheet steel carrier holds each drive, which provides thermal conduction, radio frequency, and electro-magnetic induction protection, and physically protects the drive.
The carrier provides a dual path direct dock Serial Attached SCSI interface.
Front cap ergonomic handle provides the following functions:
Secure location of the carrier into and out of drive slots.
Positive spring-loading of the drive/midplane connector.
The following figures show the supported drive carrier modules:
Figure 1. Dual path LFF 3.5 in. drive carrier module
Figure 2. Dual path SFF 2.5 in. drive carrier moduleFigure 3. Hybrid drive carrier adapter for 2.5 or 3.5 in. drives
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\