ME4 Series Storage System
controller modules can use qualified 10Gbase-T connectors or CNC-based
ports for replication.
CNC ports must use qualified SFP+ transceivers of
the same type, or they can use a combination of qualified SFP+ transceivers
supporting different interface protocols. To use a combination
of different protocols, configure host ports 0 and 1 to use FC, and configure ports 2 and 3 to use iSCSI.
FC and iSCSI ports can be used to perform host I/O or replication,
or both.
NOTE:ME4 Series 5U84 enclosures support dual-controller
configurations only. ME4 Series 2U controller
enclosures support single controller and dual-controller configurations.
If a partner controller module fails, the storage system fails over and runs on a single controller
module until the redundancy is restored.
In dual-controller module configurations,
a controller module must be installed in each slot to ensure sufficient
airflow through the enclosure during operation. In single-controller
module configurations, a controller module must be installed in slot
A, and controller module blank must be installed in slot B.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\