- Notes, cautions, and warnings
- About this guide
- Change history
- SFS fundamentals
- Setting up SFS
- Managing SmartFabric with the SFS GUI
- Access fabric setup options
- SmartFabric overview
- View fabric topology
- Manage switches in a fabric
- Configure server interface profile
- Configure and manage uplinks
- Configure networks and routing configuration
- Configure global settings for SmartFabric
- Restore fabric configuration
- View fabric compliance status
- Access fabric setup options
- SFS with VxRail
- SFS with PowerEdge MX
- SFS for Isilon/PowerScale back-end fabric
- SmartFabric commands
- smartfabric l3fabric enable
- show logging smartfabric
- show smartfabric cluster
- show smartfabric cluster member
- show smartfabric configured-server
- show smartfabric configured-server configured-server-interface
- show smartfabric details
- show smartfabric discovered-server
- show smartfabric discovered-server discovered-server-interface
- show smartfabric networks
- show smartfabric nodes
- show smartfabric personality
- show smartfabric uplinks
- show smartfabric upgrade-status
- show smartfabric validation-errors
- show switch-operating-mode
- Best Practices
- Appendix
Dell SmartFabric Services User Guide Release 10.5.3
Upgrade sequence in deployments without OMNI
This recommended order of upgrade is applicable for all SFS deployments that do not include OMNI.
- Upgrade OS10 on the switches, see SmartFabric OS10 Installation, Upgrade, and Downgrade Guide available on the SmartFabric OS10 documentation support page. Check the OS10 release notes of the respective OS10 version for any additional requirements.
- If needed, upgrade the solutions deployed with SFS such as VxRail, ESXi, and so on. See the respective solution documentation for upgrade instructions.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\