role—Enter the role of the switch in the L3 fabric:
LEAF [vlti ethernet
node/slot/port]—Specify the role as
LEAF for top of rack switches and specify the VLTi ports that interconnect the leaf switches.
NOTE Option to specify VLTi ports are not applicable for Isilon/PowerScale deployment.
SPINE—Specify the role as
SPINE for the switch that connects the leaf switches.
[domain
domain-ID]—Specify the domain ID of the switch. The domain ID can range from 100 to 107. By default, domain ID is set to 100.
Default
None
Command Mode
CONFIGURATION
Usage Information
After you enable the L3 fabric and set a role, the system prompts for confirmation to reboot to apply the mode change. If you type
Yes, the switch reboots in SmartFabric mode and a network fabric is created automatically with default fabric settings. From 10.5.3.0 release, you can enable the L3 fabric along with domain. The leaf and spine ASN and subnet prefixes is autogenerated based on the domain ID.
The
no smartfabric l3fabric command disables the L3 fabric personality. After you disable the L3 fabric in the switch, the system reboots to change the personality after confirmation.
This command is accessible to users with
sysadmin and
netadmin roles.
Example (Spine)
OS10(config)# smartfabric l3fabric enable role SPINE domain 101
Reboot to change the personality? [yes/no]: yes
Example (Leaf)
OS10(config)# smartfabric l3fabric enable role LEAF vlti
ethernet 1/1/4-1/1/5 domain 101
Reboot to change the personality? [yes/no]: yes
Example (disable SFS on both leaf and spine)
OS10(config)# no smartfabric l3fabric
Reboot to change the personality? [yes/no]: yes
Supported Releases
10.5.0.3 or later
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\