- Notes, cautions, and warnings
- About this guide
- Change history
- SFS fundamentals
- Setting up SFS
- Managing SmartFabric with the SFS GUI
- Access fabric setup options
- SmartFabric overview
- View fabric topology
- Manage switches in a fabric
- Configure server interface profile
- Configure and manage uplinks
- Configure networks and routing configuration
- Configure global settings for SmartFabric
- Restore fabric configuration
- View fabric compliance status
- Access fabric setup options
- SFS with VxRail
- SFS with PowerEdge MX
- SFS for Isilon/PowerScale back-end fabric
- SmartFabric commands
- smartfabric l3fabric enable
- show logging smartfabric
- show smartfabric cluster
- show smartfabric cluster member
- show smartfabric configured-server
- show smartfabric configured-server configured-server-interface
- show smartfabric details
- show smartfabric discovered-server
- show smartfabric discovered-server discovered-server-interface
- show smartfabric networks
- show smartfabric nodes
- show smartfabric personality
- show smartfabric uplinks
- show smartfabric upgrade-status
- show smartfabric validation-errors
- show switch-operating-mode
- Best Practices
- Appendix
Dell SmartFabric Services User Guide Release 10.5.3
Configure and manage uplinks
Uplinks enable the network fabric to communicate with the external network. Before creating an uplink, ensure that the external network is configured with the L2 or L3 setup. Any ports available on the leaf switches may be used as uplinks, provided they are compatible with the corresponding ports on the external switches.
SFS supports eBGP and static routes profiles and LACP and static for uplink bonding. For more information, see Uplinks section.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\