Configure L3 Routed uplink
Use the following procedure to create a L3 routed uplink:
- Click
Uplink >
Create.
- Enter the uplink details:
- Select the uplink port type as
Layer 3.
- Select the L3 type as
L3 Routed Interface.
- Enter the name and description (optional) for the L3 routed uplink.
- Click
Next.
- Associate an interface from the spine or leaf switch with the L3 Routed uplink.
- Click
Next.
- Associate the networks with the selected interfaces by providing a name, description (optional), interface IP address, and prefix length.
NOTE You cannot associate a L3 Routed network with more than one uplink or server profile.
- Define a routing policy to associate with the uplink based on the external network connectivity setup.
- Static Route—A route policy template that contains a network prefix and the next hop IP address.
- eBGP—A routing policy template that contains BGP peer IP address, peer AS number, and BFD configuration.
- Select the
Fabric Interconnect checkbox, if you are creating the uplink for multisite fabric interconnect purpose. See
Multisite fabric interconnect.
- Click
Finish.
The system displays uplink creation success message.
Data is not available for the Topic