Configure L3 VLAN uplink
Use the following procedure to create a L3 VLAN uplink:
- Click
Uplink >
Create.
- Enter the uplink details:
- Select the uplink type as
Layer 3.
- Select the L3 type as
L3 VLAN.
- Enter the name and description (optional) for the L3 VLAN uplink.
- Click
Next.
NOTE You can create L3 uplinks on both leaf and spine switches.
- Associate the interfaces of the spine or leaf switches with the L3 uplink:
- Select the switch group.
- Spine—Select a spine switch and an interface or multiple interfaces of the spine switch to be associated with the uplink.
- Leaf—Select a leaf switch from the rack, and an interface or multiple interfaces of the leaf switch to be associated with the uplink.
- Select the static or dynamic based on the configuration setup in the external network.
- Click
Next.
- Associate the networks with the selected interfaces:
- Select if the network is a tagged or an untagged network.
- Enter the name, description (optional), VLAN ID, IP addresses, and prefix length.
- Define a routing policy to associate with the uplink based on the external network connectivity setup.
- Click
Finish.
The system displays uplink creation success message.
Data is not available for the Topic