Complete the following steps to set up your system:
Steps
Unpack the
sled.
Remove the I/O connector cover from the
sled connectors.
CAUTION:While installing the
sled, ensure that it is properly aligned with the slot on the enclosure to prevent damage to the
sled connectors.
Install the
sled in the enclosure.
Turn on the enclosure.
NOTE:Wait for the chassis to initialize before you press the power button.
Turn on the
sled by pressing the power button on the
sled.
Alternatively, you can also turn on the
sled by using:
The
sled iDRAC. For more information, see the Log in to iDRAC section.
The enclosure Chassis Management Controller (CMC), after the
sled iDRAC is configured on the CMC. For more information, see the
CMC User’s Guide at
Dell.com/idracmanuals.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\