Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Latitude 5350/Latitude 5350 2-in-1 Owner's Manual

PDF

Removing the sensor board (laptop)

Prerequisites

CAUTION:The information in this removal section is intended for authorized service technicians only.
NOTE:The sensor board removal procedure is applicable only for the Latitude 5340 laptop and not for the 2-in-1 configuration.
  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the battery.
  4. Remove the display assembly.
  5. Remove the display bezel.
  6. Remove the display panel.

About this task

The following images indicate the location of the sensor board and provide a visual representation of the removal procedure.
Figure 1. Removing the sensor board (laptop)
Image: Removing the sensor board

Steps

  1. Open the latch and disconnect the display cable from the connector on the sensor board.
  2. Remove the display cable from the routing guides on the display assembly.
  3. Gently lift the sensor board from the display assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\