- Notes, cautions, and warnings
- Views of Latitude 5350/Latitude 5350 2-in-1
- Set up your Latitude 5350/Latitude 5350 2-in-1
- Specifications of Latitude 5350/Latitude 5350 2-in-1
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- WWAN module
- Audio
- Storage
- Keyboard
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- Sensor
- GPU—Integrated
- External display support
- Hardware security
- Smart-card reader
- Operating and storage environment
- Dell support policy
- ComfortView Plus
- Using the privacy shutter
- Dell Optimizer
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 5350/Latitude 5350 2-in-1 Owner's Manual
Removing the palm-rest assembly
Prerequisites
CAUTION:The information in this removal section is intended for authorized service technicians only.
NOTE:For models with smart card reader configuration, the smart card reader is preinstalled in the replacement palm-rest assembly.
- Follow the procedure in Before working inside your computer.
- Remove the SIM card tray (for computers with nano-SIM card option).
- Remove the base cover.
- Remove the battery.
- Remove the M.2 2230 solid state drive.
- Remove the wireless card.
- Remove the WWAN 4G card or WWAN 5G card, whichever is applicable.
- Remove the fan.
- Remove the
system board.
NOTE:The system board can be removed and installed with the heat sink attached. The removal and installation procedure is simplified to preserve the thermal bond between the system board and heat sink.
- Remove the power button or power button with optional fingerprint reader, whichever is applicable.
- Remove the smart card reader (optional).
- Remove the speakers.
- Remove the display assembly.
- Remove the SIM card slot filler (for computers without nano-SIM card option).
About this task
Steps
After performing the preceding steps, you are left with the palm rest.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\