- Notes, cautions, and warnings
- Views of Latitude 5350/Latitude 5350 2-in-1
- Set up your Latitude 5350/Latitude 5350 2-in-1
- Specifications of Latitude 5350/Latitude 5350 2-in-1
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- WWAN module
- Audio
- Storage
- Keyboard
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- Sensor
- GPU—Integrated
- External display support
- Hardware security
- Smart-card reader
- Operating and storage environment
- Dell support policy
- ComfortView Plus
- Using the privacy shutter
- Dell Optimizer
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 5350/Latitude 5350 2-in-1 Owner's Manual
Installing the speakers
Prerequisites
CAUTION:The information in this installation section is intended for authorized service technicians only.
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:The system board can be removed and installed with the heat sink attached. The removal and installation procedure is simplified to preserve the thermal bond between the system board and heat sink.
The following images indicate the location of the speaker and provide a visual representation of the installation procedure.
Steps
- Using the alignment posts, place the left and right speakers into their slots on the palm-rest assembly.
NOTE:Ensure that the four rubber grommets are seated into the slot and installed on the speakers properly.
Figure 2. Rubber grommets of speaker 
- Route the speaker cables through the routing guides on the palm-rest assembly.
- Adhere the tape to secure the speaker cables to the palm-rest assembly.
Next steps
- Install the system board.
- Install the fan.
- Install the wireless card.
- Install the WWAN 4G card or WWAN 5G card, whichever is applicable.
- Install the M.2 2230 solid state drive.
- Install the battery.
- Install the base cover.
- Install the SIM card tray (for computers with nano-SIM card option).
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\