- Notes, cautions, and warnings
- Views of Latitude 5350/Latitude 5350 2-in-1
- Set up your Latitude 5350/Latitude 5350 2-in-1
- Specifications of Latitude 5350/Latitude 5350 2-in-1
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- WWAN module
- Audio
- Storage
- Keyboard
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- Sensor
- GPU—Integrated
- External display support
- Hardware security
- Smart-card reader
- Operating and storage environment
- Dell support policy
- ComfortView Plus
- Using the privacy shutter
- Dell Optimizer
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 5350/Latitude 5350 2-in-1 Owner's Manual
Installing the SIM-card slot filler
Prerequisites
CAUTION:The information in this installation section is intended for authorized service technicians only.
If you are replacing a component, remove the necessary component before the installation procedure.
About this task
NOTE:For computers shipped without nano-SIM option, the SIM-card slot filler is a separate service part and is not included with a replacement palm rest. Hence, the SIM-card slot filler must be removed and then re-installed when replacing the palm rest.
The following images provide a visual representation of the SIM-card slot filler installation procedure.
Steps
- Place the SIM-card slot filler into its compartment on the palm rest ensuring that the SIM-card slot filler is aligned with the ribs on the palm rest.
- Press the SIM-card slot filler until you hear it click ensuring it fits securely into the SIM-card slot filler.
Next steps
- Install the palm-rest assembly.
- Install the keyboard.
- Install the display assembly.
- Install the speakers.
- Install the smart card reader (optional).
- Install the power button or power button with optional fingerprint reader.
- Install the system board.
- Install the fan.
- Install the wireless card.
- Install the WWAN 4G card or WWAN 5G card, whichever is applicable.
- Install the M.2 2230 solid state drive.
- Install the battery.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\