Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Latitude 5350/Latitude 5350 2-in-1 Owner's Manual

PDF

Installing the display panel (laptop)

Prerequisites

CAUTION:The information in this installation section is intended for authorized service technicians only.
NOTE:The display panel installation procedure is applicable only for the Latitude 5350 laptop and not for the 2-in-1 configuration.
NOTE:The display panel and its support brackets are a single assembly and cannot be further disassembled once it is removed from the display back cover. Do not remove the support brackets from the display panel.

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the display panel and provide a visual representation of the installation procedure.
Figure 1. Installing the display panel (laptop)
Image: Installing the display panel1

Steps

  1. Connect the display cable to the connector and close the latch.
  2. Adhere the adhesive strip to secure the display-cable connector.
    Figure 2. Adhering the adhesive strip to secure the display-cable connector
    Image: Adhering the adhesive strip to secure the display-cable connector
  3. Insert the display-panel tabs into the slots on the display cover.
    Figure 3. Inserting the display-panel tabs into the slots on the display cover
    Image: Inserting the display-panel tabs into the slots on the display cover
  4. Replace the two screws (M2x2.5) that secure the display panel to the display assembly.
  5. Replace the six screws (M2.5x3) that secure the right and left display hinges to the display.

Next steps

  1. Install the display hinges.
  2. Install the display bezel.
  3. Install the display assembly.
  4. Install the battery.
  5. Install the base cover.
  6. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\