- Notes, cautions, and warnings
- Views of Latitude 5350/Latitude 5350 2-in-1
- Set up your Latitude 5350/Latitude 5350 2-in-1
- Specifications of Latitude 5350/Latitude 5350 2-in-1
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- WWAN module
- Audio
- Storage
- Keyboard
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- Sensor
- GPU—Integrated
- External display support
- Hardware security
- Smart-card reader
- Operating and storage environment
- Dell support policy
- ComfortView Plus
- Using the privacy shutter
- Dell Optimizer
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 5350/Latitude 5350 2-in-1 Owner's Manual
Installing the display back-cover (laptop)
Prerequisites
CAUTION:The information in this installation section is intended for authorized service technicians only.
NOTE:The display back-cover installation procedure is applicable only for Latitude 5350 laptop and not for the 2-in-1 configuration.
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
Steps
Place the display back-cover on a flat surface and perform the following steps to install the display back cover.
Next steps
- Install the display cable.
- Install the camera.
- Install the display panel.
- Install the display hinges.
- Install the display bezel.
- Install the display assembly.
- Install the battery.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\