- Notes, cautions, and warnings
- Views of Latitude 5350/Latitude 5350 2-in-1
- Set up your Latitude 5350/Latitude 5350 2-in-1
- Specifications of Latitude 5350/Latitude 5350 2-in-1
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- WWAN module
- Audio
- Storage
- Keyboard
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- Sensor
- GPU—Integrated
- External display support
- Hardware security
- Smart-card reader
- Operating and storage environment
- Dell support policy
- ComfortView Plus
- Using the privacy shutter
- Dell Optimizer
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 5350/Latitude 5350 2-in-1 Owner's Manual
Installing the display assembly
Prerequisites
CAUTION:The information in this installation section is intended for authorized service technicians only.
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
Steps
- Place the display assembly on a clean and flat surface.
- Align and place the palm-rest assembly on the display assembly.
- Using the alignment posts, close the display hinges.
Figure 2. Installing the display assembly 
- Replace the four screws (M2.5x4) that secure the left-display hinge and right-display hinge to the system board.
- Route the WLAN-antenna cables into the routing guide underneath the fan.
- Connect the sensor cable to the system board.
- Connect the display cable to the connector (LCD1) on the system board and adhere the tape.
- Replace the screw (M2x4) that secures the display bracket to the system board.
Next steps
- Install the base cover.
- Install the SIM card tray (for computers with nano-SIM card option).
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\