- Notes, cautions, and warnings
- Views of Latitude 5350/Latitude 5350 2-in-1
- Set up your Latitude 5350/Latitude 5350 2-in-1
- Specifications of Latitude 5350/Latitude 5350 2-in-1
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- WWAN module
- Audio
- Storage
- Keyboard
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- Sensor
- GPU—Integrated
- External display support
- Hardware security
- Smart-card reader
- Operating and storage environment
- Dell support policy
- ComfortView Plus
- Using the privacy shutter
- Dell Optimizer
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 5350/Latitude 5350 2-in-1 Owner's Manual
Removing the speakers
Prerequisites
CAUTION:The information in this removal section is intended for authorized service technicians only.
- Follow the procedure in Before working inside your computer.
- Remove the SIM card tray (for computers with nano-SIM card option).
- Remove the base cover.
- Remove the battery.
- Remove the M.2 2230 solid state drive.
- Remove the wireless card.
- Remove the WWAN 4G card or WWAN 5G card, whichever is applicable.
- Remove the fan.
- Remove the system board.
About this task
NOTE:The system board can be removed and installed with the heat sink attached. The removal and installation procedure is simplified to preserve the thermal bond between the system board and heat sink.
The following images indicate the location of the speakers and provide a visual representation of the removal procedure.
Steps
- Note the routing of the speaker cable, and remove the speaker cable from the routing guides on the palm-rest assembly.
- Peel off the adhesive tape that secures the speaker cable.
- Lift the speakers along with the cable off the palm-rest assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\