From ThinOS 8.4 release, after you change the display
settings, the changes will take effect immediately without a system
restart.
Single mode user scenario
Go to System Setup > Display > General, and do the following:
Change resolution from DDC table or User defined
display settings.
Change rotation setting from User
defined display settings.
When the display settings are changed, the modified settings
are applied to the active sessions dynamically. But some of the active
sessions disconnect and then reconnect. For example, RDP for Win7
session.
Dual Head user scenario
Go to System Setup > Display > Dual Head and change the settings.
Go to System Setup > Display > General, and do the following:
Change resolution from DDC table or User defined
display settings.
Change rotation setting from User
defined display settings.
When the display settings are changed during active
sessions, the active sessions do not resize dynamically in the following
situations:
Seamless sessions
For dual head mode, including:
Change from single mode to dual head.
Change from dual head to single mode.
Change display setting in dual head
mode.
To apply the settings, disconnect the session and reconnect it.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\