Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge R750 Installation and Service Manual

PDF

Removing the VGA port

The procedure to remove VGA port from Riser 3 or 4 is same.

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the air shroud or remove the GPU air shroud.
NOTE:VGA port is supported only in slot 4 or slot 8 of the expansion card riser.

Steps

  1. Loosen the captive screws on the system.
  2. Press the blue release tab or blue button on the riser and holding the edges lift the expansion card riser from the riser connector on the system board.
  3. Disconnect the VGA port cable from the liquid cooling (LC) rear I/O board.
    Figure 1. Disconnecting the VGA port cable
    This image shows how to remove the Serial COM port.
  4. Open the latch on the expansion card riser and slide the VGA port out of the expansion card riser.
    Figure 2. Removing the VGA port
    This image shows how to remove the VGA port.
  5. Install the filler bracket if not replacing the VGA port.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\