Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge R750 Installation and Service Manual

PDF

Removing the OCP card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the expansion card riser.

Steps

  1. Open the blue latch to disengage the OCP card.
  2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
  3. Slide the OCP card out of the slot on the system.
    Figure 1. Removing the OCP card
    This image shows Removing the OCP card.
  4. If the OCP card is not going to be replaced, install a filler bracket .
    Figure 2. Installation of filler bracket
    This image shows installing of filler bracket.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\