Dell PowerEdge R750 Installation and Service Manual

Removing the BOSS S2 module

The procedure to remove is the BOSS S2 module with 4 x 2.5-inch rear drive module is same.

Pull and lift the BOSS S2 card carrier retention latch lock to open.
Slide the BOSS S2 card carrier out.
Figure 1. Removing the BOSS S2 card carrier
Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 SSD to the BOSS S2 card carrier.
Slide the M.2 SSD out from the BOSS S2 card carrier.
Figure 2. Removing the M.2 SSD
Disconnect the BOSS S2 power and signal cable from the system board.
Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the BOSS S2 module on Riser 1.
Slide the BOSS S2 module towards the front of the chassis and lift the module.
Figure 3. Removing the BOSS S2 module
Remove the BOSS S2 power and signal cable from the BOSS S2 module.
Figure 4. Removing the BOSS S2 power and signal cable from the BOSS S2 module