Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge R750 Installation and Service Manual

PDF

Removing the adapter PERC module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the expansion card riser.
  4. Disconnect all the cables from the adapter PERC (APERC) card, observe the cable routing.
NOTE:APERC module must be installed only in expansion card riser 1 or riser 2.

Steps

  1. TIlt the expansion card retention latch lock to open.
  2. Pull the card holder before removing the card from the riser.
  3. Hold the APERC module by the edges. and pull the module from the expansion card connector on the riser.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing the APERC module
    This image shows removal of adapter PERC from riser,
  4. If the APERC module is not going to be replaced, install a filler bracket and close the card retention latch.
    Figure 2. Installing the filler bracket
    This image shows Installing the filler bracket.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\