Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge R750 Installation and Service Manual

PDF

Removing the 4 x 2.5-inch rear drive module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. If required, remove the air shroud.
  4. Remove the drives.
  5. NOTE:If the BOSS S2 module is installed, ensure to disconnect the BOSS S2 power cable and Signal cable before removing the 4 x 2.5-inch rear drive module.
    Figure 1. BOSS S2 module
    Removing the BOSS power cable and BOSS signal cable from the BOSS S2 controller card module
  6. Disconnect the cables from the rear drive module.
    NOTE:Refer cable routing topic for more information.

Steps

  1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the rear drive module to the system.
  2. Lift the rear drive module from the system.
    Figure 2. Removing the 4 x 2.5-inch rear drive module
    This image shows Removing the 4 x 2.5-inch rear drive module

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\