Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge R750 Installation and Service Manual

PDF

Installing the LOM card and rear I/O board

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the system board.
NOTE:The procedure to install the liquid cooling rear I/O board and rear I/O boards is same.

Steps

  1. Align the connectors and slots on the LOM card or rear I/O board with the connector and standoffs on the system board.
  2. Press the LOM card or rear I/O board until firmly seated on the system board connector.
  3. Using a Phillips #2 screwdriver, secure the LOM card or rear I/O board to the system board with screws.
    Figure 1. Installing the LOM card and rear I/O board
    This image shows installing the LOM card and rear I/O board.
    Figure 2. Installing the liquid cooling rear I/O board
    This image shows Installing the liquid cooling rear I/O board

Next steps

  1. Install the system board.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\