Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge R750 Installation and Service Manual

PDF

Removing the rear mounting front PERC module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the drive backplane cover.
  4. If installed, remove the air shroud or remove the GPU air shroud.
  5. If required, remove the drive backplane.
  6. Disconnect all the cables, observe the cable routing.

Steps

  1. Using a Phillips #2 screwdriver, loosen the captive screws on the rear mounting front PERC module.
  2. Slide the rear mounting front PERC module to disengage from the connector on the drive backplane.
    Figure 1. Removing the rear mounting front PERC module
    This image shows Removing the rear mounting front PERC module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\