Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge R750 Installation and Service Manual

PDF

Removing the M.2 SSD module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. Remove the BOSS card.
    NOTE:Removing the BOSS card is similar to the procedure for removing an expansion card from the expansion card riser.

Steps

  1. Loosen the screws and lift the retention straps that secure the M.2 SSD module on the BOSS card.
  2. Pull the M.2 SSD module away from the BOSS card.
    Figure 1. Removing the M.2 SSD module
    This image shows removing the M.2 SSD module
    1. module connector (2)
    2. screws (2)
    3. module (2)

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\