Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge R750 Installation and Service Manual

PDF

Removing the LOM card and rear I/O board

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the system board.
    NOTE:The procedure to remove the liquid cooling rear I/O board and rear I/O boards is same.

Steps

  1. Using a Phillips # 2 screwdriver, remove the screws that secure the LAN on Motherboard (LOM) card and rear I/O board to the system board.
  2. Holding the edges, pull the LOM card or rear I/O board to disconnect from the connector on the system board.
    Figure 1. Removing the LOM card and rear I/O board
    This image shows removing the LOM card and rear I/O board.
    Figure 2. Removing liquid cooling rear I/O board
    Tihis image shows Removing liquid cooling rear I/O board

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\