Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge R750 Installation and Service Manual

PDF

Installing the VGA port

The procedure to install VGA port from Riser 3 or 4 is same.

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud or remove the GPU air shroud.
  4. Remove expansion card riser.
NOTE:VGA port is supported only in slot 4 or slot 8 of the expansion card riser.

Steps

  1. Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser.
  2. Slide the VGA port into the expansion card riser.
    Figure 1. Installing the VGA port
    This image shows how to Install the VGA port.
  3. Connect the VGA port cable to the LC rear I/O board.
  4. Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
  5. Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated on the system board connector.
  6. Tighten the captive screws on the system.
    Figure 2. Connecting the VGA port cable
    This image shows how to Install the VGA port.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\