Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge R750 Installation and Service Manual

PDF

Installing the M.2 SSD module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.

Steps

  1. Align the M.2 SSD module connectors with the connectors on the BOSS card.
  2. Push the M.2 SSD module until the module is seated firmly on the BOSS card.
  3. Secure the M.2 SSD module on the BOSS card with the retention straps and screws.
    Figure 1. Installing the M.2 SSD module
    This image shows installing the M.2 SSD module
    1. module connector (2)
    2. screws (2)
    3. modules (2)

Next steps

  1. Install the BOSS card.
    NOTE:Installing the BOSS card is similar to installing the expansion card riser.
  2. Install the air shroud.
  3. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\