Dell OpenManage Plug-in Version 1.0 For Nagios XI Installation Guide
System requirements for management systems
A management system is the server where Nagios XI is installed. The requirements for the management systems are as follows:
General requirements
Before you install the plug-in, ensure that you meet the following requirements based on the protocol you are using:
Common prerequisites:
- Any Nagios XI version between 5.2.0 to 5.2.7 is installed.
- The Net-IP Perl module version 1.26 or later is installed.
- (Optional) Java version 1.6 or later is installed to view Dell warranty information.
- (Optional) Socket6 Perl module version 0.23 or later is installed for monitoring managed systems using Internet Protocol version 6 (IPv6).
- (Optional) SNMP Trap Translator (SNMPTT) is installed to receive SNMP alerts. It is recommended to use the latest version.
- (Optional) The supported Dell Remote RACADM utility
is installed to monitor component attribute information of Dell chassis
such as:
- Speed(RPM) of the Dell Chassis Fan Status.
- InputCurrent(A) of the Dell Chassis PowerSupply Status.
- InputVoltage(V) of the Dell Chassis PowerSupply Status.
- OutputPower(W) of the Dell Chassis PowerSupply Status.
- Health of the Dell Chassis I/O Module Status .
For more information on downloading and installing the supported Dell Remote RACADM utility, go to “ en.community.dell.com/techcenter/systems-management/w/wiki/3205.racadm-command-line-interface-for-drac”
For SNMP:
The Net-SNMP Perl module version 6.0.1 or later is installed.
For WS-MAN:
OpenWSMAN and its Perl binding are installed.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\