- Notes, cautions, and warnings
- Working on your computer
- Disassembly
and reassembly
- System Overview
- Removing the Secure Digital (SD) Card
- Installing the Secure Digital (SD) Card
- Removing the ExpressCard
- Installing the ExpressCard
- Removing the Battery
- Installing the Battery
- Removing the Base Cover
- Installing the Base Cover
- Removing the Memory
- Installing the Memory
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Keyboard Trim
- Installing the Keyboard Trim
- Removing the Keyboard
- Installing the Keyboard
- Removing the WLAN Card
- Installing the WLAN Card
- Removing the WWAN Card
- Installing the WWAN Card
- Removing the Base Corner Caps
- Installing the Base-Corner Covers
- Removing the Network Connector
- Installing the Network Connector
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Heatsink Assembly
- Installing the Heatsink Assembly
- Removing the Processor
- Installing the Processor
- Removing the Power Connector
- Installing the Power Connector
- Removing the Display-Hinge Cover
- Installing the Display-Hinge Cover
- Removing the Palmrest Assembly
- Installing the Palmrest Assembly
- Removing the ExpressCard Cage
- Installing the ExpressCard Cage
- Removing the WiFi-Switch Board
- Installing the WiFi-Switch Board
- Removing the System Board
- Installing the System Board
- Removing the Speakers
- Installing the Speakers
- Removing the I/O Board
- Installing the I/O Board
- Removing the Display Assembly
- Installing the Display Assembly
- Removing the Display Bezel
- Installing the Display Bezel
- Removing the Display Panel
- Installing the Display Panel
- Removing the Display Hinges
- Installing the Display Hinges
- Removing the Camera
- Installing the Camera
- System setup
- Diagnostics
- Technical Specifications
- Contacting Dell
Dell Latitude E6440 Owner's Manual
Installing the Palmrest Assembly
- Align the palmrest assembly to its original position in the computer and snap it into place.
- Tighten the screws to secure the palmrest assembly to the computer.
-
Connect the following cables:
- media board
- Unified Security Hub (USH) board
- touchpad
- Wi-Fi board
- LED board
- Flip the computer and tighten the screws to secure the palmrest assembly to the base of the computer.
-
Install:
- base corner caps
- base cover
- display-hinge cover
- optical drive
- hard drive
- keyboard
- keyboard trim
- battery
- ExpressCard
- SD card
- Follow the procedures in After Working Inside Your Computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\