Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Dell EMC Configuration Guide for the S3100 Series 9.14.2.4

PDF

Troubleshoot CAM Profiling

The following section describes CAM profiling troubleshooting.

CAM Profile Mismatches

The CAM profile on all cards must match the system profile. In most cases, the system corrects mismatches by copying the correct profile to the card, and rebooting the card. If three resets do not bring up the card, the system displays an error message. In this case, manually adjust the CAM configuration on the card to match the system configuration.
To prevent mismatches, Dell EMC Networking recommends the following:
  • Use the eg-default CAM profile in a chassis that has only EG Series line cards. If this profile is used in a chassis with non-EG line cards, the non-EG line cards enter a problem state.
  • Before moving a card to a new chassis, change the CAM profile on a card to match the new system profile.
  • After installing a secondary RPM into a chassis, copy the running-configuration to the startup-configuration.
  • Change to the default profile if downgrading to a Dell EMC Networking OS version earlier than 6.3.1.1.
  • Use the CONFIGURATION mode commands so that the profile is change throughout the system.
  • Use the EXEC Privilege mode commands to match the profile of a component to the profile of the target system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\