Loading Ubuntu on Systems Using PCIe M2 Drives

This article provides information about how to install Ubuntu on systems using PCIe M2 drives.

Hard Drive Not Seen

When booting to the Ubuntu 14.04 / 15.04 media on a system that only has a PCIe based m2 drive. You may see that the Installer cannot locate a hard drive (the installer only looks for /dev/sdx by default) (Figure 1).

Figure 1

NVME Load

Add the following kernel argument at boot time:
nvme_load=YES

• Press F12 when you see the keyboard prompt (Figure 2):
  
  Figure 2
   
• Press Enter to select Language
• Press F6
• Press Esc
• Modify the boot option to add "nvme_load=YES" and remove "quiet splash ---"
  Before (Figure 3):
  
  Figure 3
  
  After (Figure 4):
  
  Figure 4
  
  Press Enter.

The NVME drive is now available in the installer (Figure 5):

Figure 5

• Controller: Nvme0
• Port: N1
• Partition: Px

More Information about Ubuntu

• SLN151664 - How to Install Ubuntu Linux on your Dell PC
• SLN301754 - How to Install Ubuntu and Windows 8 or 10 as a Dual Boot on your Dell PC

If you have further questions about this article, contact Dell Technical Support.

Recommended Articles

Here are some recommended articles related to this topic that might be of interest to you.

• How to Install Ubuntu Developer Edition 14.04 on a Dell PC Configured for the Unified Extensible Firmware Interface (UEFI) BIOS
• How to Upgrade your Ubuntu Operating System to the Latest Version
• Ubuntu Frequently Asked Questions
• How to recover a Dell Ubuntu Image on your Dell Computer
• How to Install Ubuntu and Windows 8 Through Windows 11 as a Dual Boot on your Dell Computer