XtremIO: How to find the serial number of an XtremIO array
Sammanfattning:The purpose of this article to help locating the PSTN - Serial Number of the XtremIO array
Välj en produkt för att kontrollera artikelns relevans
Den här artikeln gäller för Den här artikeln gäller inte förDen här artikeln är inte kopplad till någon specifik produkt.Alla produktversioner identifieras inte i den här artikeln.
Unable to locate the PSNT - serial number of the XtremIO array.
Orsak
Unable to locate the PSNT - serial number of the XtremIO array.
Upplösning
METHOD 1 (XtremIO GUI):
Version 3.x (or earlier)
From the Dashboard home page, click the Hardware tab.
The PSNT - Serial Number is listed under the X-Brick Icon.
Sample Output:
PSNT Serial Number: APM00123456789
XMS Version 4.x
In the GUI, click the System Administration tab in the upper menu.
Click Clusters in the left-hand menu (may already be selected).
The cluster serial numbers are listed in the PSNT column.
Sample Output:
XMS Version 6.x
Click the Inventory button on the left menu.
Click the Clusters button in the main panel.
The cluster serial numbers are listed in the PSNT column.
Sample Output:
METHOD 2 (XMCLI from GUI): (Note: For sample CLI output, see the Notes section)
Version 3.x (or earlier)
Click the Administration icon at the top of the page.
Select the CLI (Command Line Interface) tab.
Log in to the XMCLI
Run the XMCLI Command: show-clusters-info
The serial number is in the PSNT column.
Sample Output:
XMS Version 4.x
Follow the procedure for 3.x above, but positioning of the buttons is slightly different.
Sample Output:
XMS Version 6.x
There is no access to CLI using the GUI in version 6.x. See Method 3 below for an alternative method to access CLI.
METHOD 3 (XMCLI from an SSH client):
All versions:
From the SSH client, enter either the IP address or hostname of the XMS using port 22
When a prompt appears with "login as:", enter xmsadmin and then enter the password when prompted for it
The CLI then prompts for "Username:." Either enter admin or a similar username with administrator access, and enter the password when prompted
Run the XMCLI Command: show-clusters-info
The serial number is in the PSNT column. For an XMS managing multiple clusters, there will be is a list of clusters in this output.
Ytterligare information
Sample XMCLI output:
Username: admin Password: xxxxxxxxxx
Connect to XMS on 10.x.x.x:443: version 3.x.x build xx xmcli (admin) show-clusters-info Cluster-Name Index State Conn-State Activation-Time Start-Time SW-Version PSNT Encryption-Mode Encryption-Supported Mode-Switch-Status Compression-Mode SSH-Firewall-Mode XtremIO 1 active connected Thu May 14 16:14:40 2015 Thu May 14 16:14:40 2015 3.x.x-xx APM00123456789 disabled No none enabled unlocked