Preskočiť na hlavný obsah
Odhlásiť sa

Vitajte v spoločnosti Dell!

Moje konto
  • Zadávajte objednávky rýchlo a jednoducho
  • Pozrite si svoje objednávky a sledujte priebeh doručenia
  • Vytvorte si zoznam svojich produktov a majte ho vždy poruke
Prihlásiť sa Vytvoriť konto Prihlásenie na stránky Premier Prihlásenie do partnerského programu
Kontaktujte nás

Fixing Switchable Graphics on a Laptop after Disabling Base Graphics or Re-imaging

Zhrnutie: This article provides information about resolving an issue where the video goes faulty after a re-image or disabling base graphics on a switchable graphics enabled laptop.

Tento článok sa vzťahuje na Tento článok sa nevzťahuje na Tento článok nie je viazaný na žiadny konkrétny produkt. V tomto článku nie sú uvedené všetky verzie produktov.
Pozrite si ďalšie zdroje

Pokyny

Are you seeing an issue with discrete graphics after disabling Optimus?

 

If you are seeing the following problem on your laptop, follow the solution guide below.

If you have disabled the integrated or UMA graphic in Device Manager > Display Adapters, to get better video performance. A yellow bang appears against the discrete graphic card with an error message like Windows has stopped this device because it has reported problems (Code 43). The external displays, if you have one installed, stop working simultaneously. If you shut down or restart the laptop, the fault continues.

switching video

 
Note: This failure symptom can also be seen if the laptop has been re-imaged. However, the integrated or UMA graphic driver was not installed prior to installing the discrete graphics driver.
 
Note: Ensure that the integrated or UMA graphic driver is installed prior to the discrete graphics driver (both installed).
 

Follow these steps:

  1. Enable the integrated or UMA graphic from Device Manager > Display Adapters and then reboot as it can bring the laptop back to the previous working state.

  2. Ensure that performance and power-saving optimization is set correctly.

    • For laptops with NVIDIA discrete graphics - Enable or Disable the Optimus option by pressing the F2 key and going into the BIOS setup > Video > Optimus.

    • For laptops with AMD discrete graphics - Select the option for Powersaving/Performance within the Control Panel > Catalyst Control Center(CCC) > Start. 

 


Back to Top

Dotknuté produkty

G Series, Alienware, Inspiron, Latitude, Vostro, XPS
Vlastnosti článku
Číslo článku: 000134603
Typ článku: How To
Dátum poslednej úpravy: 30 aug 2024
Verzia:  5
Nájdite odpovede na svoje otázky od ostatných používateľov spoločnosti Dell
Služby podpory
Skontrolujte, či sa na vaše zariadenie vzťahujú služby podpory.