Ga naar hoofdinhoud
Uitloggen

Welkom bij Dell

Mijn account
  • Snel en eenvoudig bestellen
  • Bestellingen en de verzendstatus bekijken
  • Een lijst met producten maken en openen
Inloggen Een account maken Inloggen bij Premier Aanmelden voor partnerprogramma
Contact

Uw Dell.com-winkelwagentjes

How to connect the battery on new APC UPS before use

Samenvatting: New Uninterruptable Power Supplies (UPS) are delivered with the battery disconnected. Here you find the steps how to connect the battery.

Dit artikel is van toepassing op   Dit artikel is niet van toepassing op 
Bronnen bekijken voor

Symptomen

A new APC Uninterruptible Power Supply (UPS) is usually shipped with the battery disconnected. This article explains how to connect the battery.

Oorzaak

NOTE: In Compliance with Department Of Transportation (DOT) regulations, APC Uninterruptible power supply (UPS) are shipped with the battery disconnected. The unit will not operate until the battery is connected.

Oplossing

Connect the Battery in the New APC UPS

If you receive a APC UPS which does not function, please make sure the battery is connected. Perform the following steps:

  1. Open the battery compartment

  2. Pull the battery out half way

  3. Connect the Red Battery Wire to the + Positive battery terminal

  4. Push the battery into the compartment and re-install the cover

NOTE: Batteries on average take at least 6 hours to charge. For additional information on connecting and charging the battery, go to the APC Manual Page.

Getroffen producten

Dell UPS 1000R, Dell UPS 1920R, Dell UPS 2700R, Dell UPS 5600R, Dell UPS 1920T, Dell UPS 500T, Dell UPS 3750R, Dell UPS 4200R, Liebert NX UPS