In exec mode, verify that the management interface configuration is correct:
OS10# show running-configuration interface mgmt 1/1/1 ! interface mgmt1/1/1 no shutdown no ip address dhcp ip address 1.1.1.1/24 ipv6 address autoconfig OS10#
Show the management route is present and correct:
OS10# show running-configuration management-route ! management route 0.0.0.0/0 1.1.1.2 OS10#
Instructions for setting up an admin level user:
Open the CLI using the console or management IP for the S-series switch.
Log into the privileged exec mode as default credentials. (OS10: user=admin, password=admin).
To modify the switch configuration, run the “configure terminal” command then press enter.
OS10# configure terminal OS10(config)#
Configure a username ‘test’ and password with sysadmin privileges: username<string> password <string> role <sysadmin/netoperator/secadmin/netadmin>
OS10(config)#username test password P@ssw0rd!123 role sysadmin
Exit config mode to exec mode:
OS10(config)# end OS10#
Verify the users configured on system:
OS10# show running-configuration users username test password **** role sysadmin priv-lvl 15 OS10#
Save the running configuration to startup configuration: