This page lists support articles to manage Tape Libraries (TL1000, TL2000, and so on,..) and troubleshoot them upon failure (drive cannot be ejected from the library).
- Table of content - Tape Libraries FAQ and Management
|
|
|
|
|
|
|
LTO Error code table
| SCD Code |
Description |
| 0 |
No Error. Ran successfully. |
| 1 |
Cooling problem. |
| 2 |
5V dc power problem. Tape drive detected that the Drive Power Supply is approaching the specified voltage limit (drive is still operating) or is outside the specified voltage range (drive is not operating). |
| 3 |
Tape drive determined that a microcode error occurred. |
| 4 |
Microcode or tape drive problem. Tape drive determined that a microcode or tape drive hardware failure occurred. |
| 5 |
Tape drive problem. Tape drive determined that a hardware failure occurred. |
| 6 |
Tape drive or media error. Tape drive determined that an error occurred, but it cannot isolate the error due to faulty hardware or to the tape cartridge. |
| 7 |
Media error. |
| 8 |
Tape drive, SCSI bus or fibre channel error. |
| 9 |
Tape drive or RS-422 error. |
| A |
Tape drive hardware problem. |
| B |
No error or message is assigned. |
| C |
Tape drive needs to be cleaned. |
| D |
No error or message is assigned. |
| = |
The Unload button on the drive was pushed in and did not release. |