文書番号: 000121358

How to perform interface range commands on Force10 Switches

概要: how to use range command on Dell Force10 switch, Dell Force10 how to use interface range command

この記事は自動翻訳されたものである可能性があります。品質に関するフィードバックがある場合は、このページの下部にあるフォームを使用してお知らせください。

文書の内容

手順

This article explains how to configure multiple interfaces or VLANs at the same time.

Table of Contents

1. Configure multiple interfaces at the same time
2. Configure multiple VLANs at the same time

Configure multiple interfaces at the same time

To configure multiple interfaces at the same time, go into an interface range command.

Input the following commands to enter a range of interfaces.

ftos>enable

ftos#configure

For consecutive ports, the following example uses 10-Gigabit Ethernet ports 2-5 on Unit 0

ftos(config)#interface range te 0/2 - 5

For non-consecutive ports, the following example uses 10-Gigabit Ethernet ports 48 on Unit 0 and 3

ftos(config)#interface range te 0/48 , te 3/48

Note: Notice that starting after range there are spaces after every input in the rest of the command syntax for both examples

Note: To verify the way the ports are defined on your switch, you can run an ftos#show interfaces status

Below is an example to configure the 10-Gigabit Ethernet consecutive ports 1 through 5, as well as 8 and 9 on unit 0

ftos(config)#interface range gi 0/1 - 5 , gi 0/8 , gi 0/9

Note: You may configure different interface types at the same time, such as a Gigabit Ethernet, and 10-Gigabit Ethernet interface

Note: If the syntax of the desired range command is large, it may be easier to type it in notepad and then paste it in the command line.

Note: Non existing interfaces are excluded from bulk configuration

Configure multiple VLANs at the same time

Note: Interface range for VLANs does not create new VLANs. It will only configure existing VLANs. Non existing interfaces are excluded from bulk configuration

To configure multiple VLANs at the same time, go into an interface range command.

Input the following commands to enter a range of VLANs.

For consecutive VLANs, the following example uses VLANs 2-10

ftos(config)#interface range vlan 2 - 10

For non-consecutive VLANs, the following example uses VLANs 15 and 20

ftos(config)#interface range vlan 15 , vlan 20

Note: Notice that starting after range there are spaces after every input in the rest of the command syntax for both examples

Below is an example to configure the VLANs 2 through 10, as well as 15 and 20.

ftos(config)#interface range vlan 2 - 10 , vlan 15 , vlan 20

文書のプロパティ

影響を受ける製品

Force10 S60-44T

最後に公開された日付

10 4月 2021

バージョン

文書の種類

How To

トップに戻る

ようこそ

Dellへようこそ