XtremIO: Het serienummer van een XtremIO-array vinden (in het Engels)
Résumé:The purpose of this article to help locating the PSTN - Serial Number of the XtremIO array
Sélectionnez un produit pour vérifier la pertinence de l’article
Cet article concerne Cet article ne concerne pasCet article n’est associé à aucun produit spécifique.Toutes les versions du produit ne sont pas identifiées dans cet article.
Unable to locate the PSNT - serial number of the XtremIO array.
Cause
Unable to locate the PSNT - serial number of the XtremIO array.
Résolution
METHOD 1 (XtremIO GUI):
Version 3.x (or earlier)
From the Dashboard home page, click the Hardware tab.
The PSNT - Serial Number is listed under the X-Brick Icon.
Voorbeeldresultaat:
PSNT Serial Number: APM00123456789
XMS Enterprise versie 4.X:
In the GUI, click the System Administration tab in the upper menu.
Click Clusters in the left-hand menu (may already be selected).
The cluster serial numbers are listed in the PSNT column.
Voorbeeldresultaat:
XMS Version 6.x
Click the Inventory button on the left menu.
Click the Clusters button in the main panel.
The cluster serial numbers are listed in the PSNT column.
Voorbeeldresultaat:
METHOD 2 (XMCLI from GUI): (Opmerking: For sample CLI output, see the Notes section)
Version 3.x (or earlier)
Click the Administration icon at the top of the page.
Select the CLI (Command Line Interface) tab.
Meld u aan bij de XMCLI
Run the XMCLI Command: show-clusters-info
The serial number is in the PSNT column.
Voorbeeldresultaat:
XMS Enterprise versie 4.X:
Follow the procedure for 3.x above, but positioning of the buttons is slightly different.
Voorbeeldresultaat:
XMS Version 6.x
There is no access to CLI using the GUI in version 6.x. See Method 3 below for an alternative method to access CLI.
METHOD 3 (XMCLI from an SSH client):
Alle versies.
From the SSH client, enter either the IP address or hostname of the XMS using port 22
When a prompt appears with "login as:", enter xmsadmin and then enter the password when prompted for it
The CLI then prompts for "Username:." Either enter admin or a similar username with administrator access, and enter the password when prompted
Run the XMCLI Command: show-clusters-info
The serial number is in the PSNT column. For an XMS managing multiple clusters, there will be is a list of clusters in this output.
Informations supplémentaires
Sample XMCLI output:
Username: admin Password: xxxxxxxxxx
Connect to XMS on 10.x.x.x:443: version 3.x.x build xx xmcli (admin) show-clusters-info Cluster-Name Index State Conn-State Activation-Time Start-Time SW-Version PSNT Encryption-Mode Encryption-Supported Mode-Switch-Status Compression-Mode SSH-Firewall-Mode XtremIO 1 active connected Thu May 14 16:14:40 2015 Thu May 14 16:14:40 2015 3.x.x-xx APM00123456789 disabled No none enabled unlocked